PTCL Flash Fiber Speed Test
Updated 22 October 2026 · PTCL Speed Check guide
Use the tester above to check your PTCL Flash Fiber speed. For an accurate result, test on a LAN cable, then on 5 GHz WiFi, and compare both with your package.
What speed should Flash Fiber give?
| Package | Expected on LAN cable | Expected on 5 GHz WiFi (same room) | 2.4 GHz WiFi |
|---|---|---|---|
| 30 Mbps | 27–31 Mbps | 25–30 Mbps | 15–25 Mbps |
| 40 Mbps | 36–41 Mbps | 32–40 Mbps | 18–30 Mbps |
| 50 Mbps | 45–52 Mbps | 40–50 Mbps | 20–35 Mbps |
| 100 Mbps | 90–100 Mbps | 70–95 Mbps | 25–45 Mbps |
| 300 Mbps | 270–300 Mbps (gigabit port) | 150–280 Mbps (WiFi 5/6 device) | 30–60 Mbps |
These are typical ranges, not guarantees. WiFi results depend heavily on your phone or laptop, walls and distance. Upload speed on Flash Fiber is usually lower than download.
How to test properly
- Connect a laptop to the router with a LAN cable (Cat5e or better).
- Pause downloads, Netflix and phone backups on other devices.
- Run the test 3 times and take the middle result.
- Repeat at night (8–11 pm) to check peak-hour speed.
- Then test on 5 GHz WiFi near the router to see how much WiFi costs you.
Fiber slow? Check these
- Signal power: open the router page and read Rx optical power. Between -8 and -25 dBm is healthy. See fiber signal strength.
- LOS light red: fiber cut or bent; call 1218. See router lights.
- Good on cable, bad on WiFi: switch to 5 GHz, move the router to a central spot, or remove WiFi freeloaders.
- Lag in games but fine speed: run the ping test and packet loss test.
For all fixes see why PTCL internet is slow. Considering an upgrade? Check Flash Fiber packages. For regular PTCL DSL lines, use the main PTCL speed test.
Frequently asked questions
What is a good Flash Fiber speed?
On a LAN cable you should get about 90 percent or more of your package speed. On 5 GHz WiFi near the router, 70 to 95 percent is normal.
Why is my Flash Fiber slow on WiFi but fast on cable?
WiFi loses speed through walls, on the 2.4 GHz band and with older devices. Use 5 GHz and keep the router central.
What fiber signal (dBm) is good for PTCL Flash Fiber?
An Rx power between about -8 and -25 dBm is healthy. Weaker than -27 dBm usually causes drops.